Abit IP35 PRO XE User Manual download pdf (Page 11)

Hardware Setup

IP35 Pro 1-7

1.6.2 Front Panel Switches & Indicators Headers

This header is used for connecting switches and LED

indicators on the chassis front panel.

Watch the power LED pin position and orientation. The

mark “+” ali

n to the pin in the fi

ure below stands for

positive polarity for the LED connection. Please pay

attention when connecting these headers. A wrong

orientation will only result in the LED not lighting, but

a wrong connection of the switches could cause

system malfunction.

• HLED (Pin 1, 3):

Connects to the HDD LED cable of chassis front

panel.

• RST (Pin 5, 7):

Connects to the Reset Switch cable of chassis

front panel.

• SPKR (Pin 13, 15, 17, 19):

Connects to the System Speaker cable of chassis.

• SLED (Pin 2, 4):

Connects to the Suspend LED cable (if there is

one) of chassis front panel.

• PWR (Pin 6, 8):

Connects to the Power Switch cable of chassis

front panel.

• PLED (Pin 16, 18, 20):

Connects to the Power LED cable of chassis front

panel.

1.6.3 FAN Power Connectors

These connectors each provide power to the

cooling fans installed in your system.

• CPUFAN1: CPU Fan Power Connector

• SYSFAN1: System Fan Power Connector

• AUXFAN1~4: Auxiliary Fan Power

Connector

※ Either a

3-pin

4-pin

CPU cooling

fan connected to the “CPUFAN1”

connector is still capable of having its

fan speed controlled. Please refer to

the BIOS setup route: “PC Health

Status”  “ABIT FanEQ Control” 

“CPU FAN Type” to select the one of

your own.

※ These fan connectors are not jumpers. DO NOT place jumper caps on these

connectors.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 87 88

Comments to this Manuals

No comments

Abit IP35 PRO XE User Manual Page 11

Comments to this Manuals

Related products and manuals for Motherboards Abit IP35 PRO XE