D-8 Appendix D
BP6
Step 7:
After you configure your hard disk
and specify the installation path, the NT
setup will ask you to insert the Ultra ATA/66
driver disk into drive A again. Insert the
driver disk, and then press "
ENTER
" to
continue setup.
If you have followed the steps described above, you should be finished installing your Ultra
ATA/66 controller. For the rest of Windows NT installation steps, please follow the
instructions displayed in the NT setup program.
Installing drivers with existing Windows NT:
If there is an existing NT 4.0 file system, you can install the Ultra ATA/66 into the existing
system by following procedure:
Step 1:
Open "
Control Panel
", and then
enter "
SCSI Adapters
".
Step 2:
Select "
Drivers
", and then click
"
Add…
"
Comments to this Manuals