Abit NV8 User Manual download pdf (Page 13)

Hardware Setup 2-5

2-4. Connectors, Headers and Switches

Here we will show you all of the connectors, headers and switches, and how to connect them. Please read

the entire section for necessary information before attempting to finish all the hardware installation inside

the computer chassis. A complete enlarged layout diagram is shown in Chapter 1 for all the position of

connectors and headers on the board that you may refer to.

WARNING: Always power off the computer and unplug the AC power cord before adding or removing

any peripheral or component. Failing to so may cause severe damage to your motherboard and/or

peripherals. Plug in the AC power cord only after you have carefully checked everything.

ATX Power Input Connectors

(1).

This motherboard provides two power connectors to connect ATX12V power supplier.

NOTE: This 24-pin power connector “ATXPWR1” is compliant to the former 20-pin type. Pay attention

to the orientation when doing so (Pin-11, 12, 23, and 24 should be left un-connected).

Note: It is recommended to connect to a power with 350W, 20A +5VDC capacity at least for heavily

loaded system, and a 2A +5VSB capacity at least for supporting wake-up features.

The auxiliary 12V power connector [ATX4P1] provides an additional power

source for devices added on PCI Express slots. It is highly recommended to

attach 12V power from the power supplier for the best system stability.

User’s Manual

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 71 72

No comments

Abit NV8 User Manual Page 13