Abit Socket 462 System Board User's Guide download pdf (Page 109)

ASUS A7V333 motherboard user guide

5.4.5 Other FastBuild Utility Commands

Command options 3-6 on the FastBuild™ Utility Main Menu are not required

for setting up an array, but they are useful for reconfiguring an array:

View Array (3): View the drive assignments of hard disks in an array.

Delete Array (4): Deletes an array to reconfigure the system. Deleting an

array does not remove information on the hard disks. If an array is deleted

by mistake, recover it immediately by redefining it as the deleted array.

Rebuild Array (5): This command restores the array and system data after

faults on RAID 1 arrays. Follow the steps below to rebuild and restore data

in the array:

1. On boot-up, an error message notifies of a system failure.

2. Press <Ctrl-F> keys to enter the FastBuild™Main Menu.

3. Select <3> for View Array to verify the ID of the defunct hard disk.

4. Power off the system and replace the hard disk with an identical model.

5. Reboot and enter the FastBuild™ Main Menu again.

6. Select <5> for Rebuild Array. The malfunctioning array is highlighted.

Press <Enter> to select it:

[ Keys Available ]

[ ] Up [ ] Down [ESC] Exit [Enter] Select

[ Rebuild Array Menu ]

Array No RAID Mode Total Drv Capacity Status

Array 1 Mirror 2 1628 Critical

Array 2 ----- ----- ----- -----

Array 3 ----- ----- ----- -----

Array 4 ----- ----- ----- -----

[ Keys Available ]

[ Select Drive for Rebuild ]

[ ] Up [ ] Down [ESC] Exit [Enter] Select

[ Rebuild Array Menu ]

Array No RAID Mode Total Drv Status

Array 1 Mirror 2 Critical

Stripe Block: Not Available

Channel: ID Drive Model Capacity (MB)

1: Slave ST3322IA 3077

7. Select the replacement drive. Press <Enter>:

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 139 140

No comments

Abit Socket 462 System Board User's Guide Page 109