Abit KR7A-RAID User Manual download pdf (Page 68)

4-4 Chapter 4

KR7A/KR7A-RAID

Note

When you choose to create RAID 1 and your source disk is not empty. You have to Duplicate Mirror

Disk to copy the data to the destination disk. Otherwise, it will only copy the partition table to the

destination disk, not the physical date.

Select Disk Drives:

This item allows you to select the disk drives to be used with the RAID array.

Stripe Size:

This item allows you to select the block size of the RAID array. There are five options: 4K, 8K, 16K, 32K,

and 64K.

Start Creation Process:

After you have made your selection, choose this item and press <Enter> to start creation.

4-3-2. OPTION 2: Delete RAID

This item allows you to remove a RAID Array on this IDE RAID controller card.

Note: After you have made and confirmed this selection, all the data stored in the hard disk will be lost.

(The entire partition configuration will be deleted too.)

4-3-3. OPTION 3: Rebuild Mirror Array

This item allows you to select the disk you wish to rebuild in preparation for a “Mirror Disk Array”.

After you have selected the function you want in the main menu, you may press the <Enter> key to enter

the sub menu as shown below:

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 103 104

No comments

Abit KR7A-RAID User Manual Page 68