Abit KR7A-RAID User Manual download pdf (Page 57)

Introducing the BIOS

User’s Manual

3-29

IRQ/Event Activity Detect:

The following is a list of IRQ’s (Interrupt ReQuests) and list of the events. When an I/O device wants to

gain the attention of the operating system, it causes an IRQ or event to occur. When the operating system

is ready to respond to the request, it interrupts itself and performs the service.

Figure 3-7B. IRQ/Event Activity Detect Setup Menu

VGA:

Two items available: OFF or ON. The default setting is OFF. When set to ON, any event occurring at a

VGA port will awaken a system that has powered down.

LPT & COM:

Four items are available: NONE ) LPT ) COM ) LPT/COM. The default setting is LPT/COM. When

set to LPT/COM, any event occurring at a LPT (printer) or COM (serial) port will awaken a system that

has powered down.

HDD & FDD:

Two items are available: OFF or ON. The default setting is ON. When set to ON, any event affecting a

hard disk drive or floppy drive port will awaken a system that has powered down.

PCI Master:

Two items are available: OFF or ON. The default setting is OFF. When set to ON, any event affecting the

PCI Master signal will awaken a system that has powered down.

PowerOn by PCI Card:

Two items are available: Disabled or Enabled. The default setting is Disabled. When set to Enabled, any

event affecting PCI card will awaken a system that has powered down.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 103 104

No comments

Abit KR7A-RAID User Manual Page 57