Abit TX5 User's Guide download pdf (Page 58)

4 Getting Started

Shutting down the laser scanner

To shut down the laser scanner, shortly press the Power button or use the shutdown button in the

operating software under Manage. All LEDs will start blinking yellow. As soon as the laser scanner

has finished the shutdown process the LEDs will stop blinking and you can safely remove the battery

and the power supply.

DO NOT turn off the power of the laser scanner before the shut down cycle is complete. The laser

scanner has a PC with an integrated hard drive. This internal PC must be shut down before turning

off the power supply. If the power supply is disconnected or switched off without the laser scanner

being previously shut down, it may damage the internal PC and might lead to a loss of data.

Pressing and holding the button more than 10 seconds will switch the laser scanner off without

shutting down. Only if the laser scanner does not shut down normally because of a malfunction.

Note – If the laser scanner has not been shut down properly, the next boot process could take

more time than usual as the laser scanner checks the hard disk for errors. Some settings, which

were made shortly before shutting down the laser scanner, might also be lost.

Trimble TX5 3D Laser Scanner User Guide 58

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 124 125

No comments

Abit TX5 User's Guide Page 58